Home > Exhibition > Content

How to build an aluminum scaffold

Sep 12, 2019

The steps to build an aluminum scaffold are generally divided into thirteen steps. The specific steps are as follows:

1. First set the four bases in the approximate position on the ground, and adjust the lower legs to make them in a horizontal plane;

2. Insert the bottom part of the inclined support on the outer side of the base on the four corners, and insert 2 pieces into each corner for a total of 8 pieces;

3 Fix the counter head to the base with screws, and note that the direction of rotation of the counter head should be the same as that marked in the figure;

4. Set the square cover on the counter head;

5. Connect the beams on the ground;

6. The two ends of the beam are respectively connected to the two square sleeves on both sides, and the beam portion is assembled on the ground;

7. Connect the column truss flat and lay it, then screw one end to the opposite head and the other end to the cross arm. At the same time, link the hanging hoist and cross arm. The function of the hoist is to raise the lower beam truss. ;

8, a number of people together put the column truss slowly up, be careful not to push the column too much force, and then fix the screw above the head;

9. After the column is erected, hook the hook below the hanging hoist to the lower beam through the sling;

10, 4 people slowly swayed the hanging hoist to pull the beam to the left and right position of the person's head;

11. Install lighting and sound equipment on the beam;

12, 4 people swayed the hoist together to the predetermined height to stop;

13. Tighten one end of the diagonal support and the column, and tighten the other end with the horizontal support of the base, so that the aluminum frame is completed.https://www.aluscaffold.com/